Cane Creek's Thud Glove protects the moving parts of your Thud Buster seatpost from dirt and weather. Available in both short- and long-travel models.
Interlok spacers nest into the lip of Cane Creek headset uppers for a rock solid, flex-free fit. - Composite construction
Installation of air volume reducers for Cane Creek shocks make the spring rate more progressive. - Spacers can be cut to fine-tune spring curve
Replacement elastomers for Thudbuster ST suspension seatposts allow the rider to tune for weight.
A higher quality spring greatly improves the performance of your coil shock. VALT springs from Cane Creek are much lighter than traditional steel springs while pushing the boundaries of performance and durability. - Inner diameter of 36.5mm is compatible with all Cane Creek coil shocks - Also compatible with Manitou, Marzocchi, XFusion, ELKA/MRP, BOS and DSP - Compatible with Fox coil shocks with required spring clip adaptor
Rebuild kits come with everything you need to service moving parts on a Cane Creek Thudbuster suspension seatpost. - Rebuild bushing tools - LT arm screws (M4 x 20mm) - Saddle clamp bolt (M5 x 35mm) - Saddle clamp spherical washers - Saddle clamp adjustment knob
$19.50 - $26.50
Mounting hardware fits a variety of Cane Creek shocks.
The OPT remote allows instant engagement of Cane Creek's Climb Switch on Double Barrel rear shocks, giving the rider precise control of traction and climbing feel. - Hard anodized for durability - Requires brake cable and housing for installation - Bottom mount for below bar engagement or top mount for above bar - Compatible with DBinline, DBAir IL, and DBCoil IL shocks only
Replacement elastomers for Thudbuster LT suspension seatposts allow the rider to tune for weight.
Replacement top subassemblies are compatible across Cane Creek 110-, 40-, and 10-Series headsets with the same SHIS values. - Bearings not included - Stack height = 9mm
- Enables Double Barrel springs (1.43" ID x 2.10-2.19 OD) to be run on other brand shocks
Replacement top subassemblies are compatible across Cane Creek 110-, 40-, and 10-Series headsets with the same SHIS values. - Bearings not included - Stack height: 9mm
Replacement springs for Cane Creek Helm suspension forks.
Hellbender bearings have an improved seal structure and are cross compatible with Cane Creek headsets.
Page 1 of 1